Follow

Fresco FCS7 Release Notes - 200

Fresco 7" Touch Screen Version 2.00

Version 200.50

New Features

  • Added support for new Winline 501 DMX fixtures

Bugs Fixed

  • Fixed color temperature fade for DMX outputs
  • Fixed lighting state restore when multiple devices have outputs in the same zone
  • Fixed issue where updating firmware on RBs and AVIs failed

Known Issues

  • DMX color temperature limits require manual sync after power up
  • Mobile app does not support scene toggle

 

Version 200.42

New Features

  • Added a System Diagnostics tab which displays available memory
  • Unmasking an occupancy sensor updates the output if the sensor became vacant while masked

Bugs Fixed

  • Color temperature limits failed to sync across multiple Frescos
  • nLight "Add all" button cleared zone assignments
  • Input masking/unmasking did not work across networks
  • Some Frescos would fail to connect via Ethernet

 Known Issues

  • Updating RB and AVIs fail. Update with version 200.38 first and then update Fresco Touchscreen to this version.
  • Mobile app does not support scene toggle

 

 

Version 200.38

Bugs Fixed

  • Uncontrolled reset when controlling large systems
  • Channel control zone selector only shows first 255 zones
  • DMX flicker when performing FCN operations
  • Scene button activation state incorrect after unlinking
  • Room link state lost after a restart on a non-master Fresco

Version 200.36

New Features

  • Lighting levels preserved after reset or power failure
  • 72 Channels in each Fresco room
  • nLight ARP setup experience improved (including Fresco Studio support)
  • Scene save protection to prevent invalid scenes
  • Scene are now able to toggle on/off
  • New nLight devices highlighted when connected
  • Offline nLight devices shown with red text
  • Fresco now displays nLight global channel utilization on diagnostics screen
  • nLight firmware version added to setup tree
  • Searchable DMX Device List
  • Uptime status of Fresco devices on diagnostics screen and in Fresco Studio
  • FCN devices requiring firmware updates shown with red text
  • Scripting – Adds ability to setup conditional logic and loops
  • Fresco Protocol updates

Bugs Fixed

  • General UI improvements for readability and consistency
  • DMX color temperature fixture 1440 does not appear to turn on
  • nTune fixture flashes and goes full bright
  • Mobile app unable to control Fresco
  • Wallpods are put in wallpod mode (specifically nPODM 4S DX EDUTW which is not its default).

 Known Issues

  • nIO 1S will lose programming during update to v200
  • BACnet COV only supports one subscription
  • Mobile app does not support scene toggle

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request