Identify a connected shade

A shade connected to a configured FCS AVI can be identified much like a light fixture pulsing on and off, instead the shade cycles open and closed.

Navigation to the FCS AVI configuration, Menu -> Setup -> FCN on the FCS7 touchscreen.

Expand the shade outputs

Tap address field and select an available shade serial number.

Note: If there are no serial numbers, the third party shade interface may not be properly configured as there may be communications issues. In a properly configured shade interface, a list of serial numbers of available shades will be displayed.

The shade serial number is now assigned to that specific shade output.

Select the shade output, and press the Identify button.

The shade should begin cycling open and closed, until the identify operation is cancelled on the touchscreen, or the identify period times out (30 minutes).

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request