Follow

Replacing a photocell sensor with Fresco

If a photocell sensor is to be replaced in a Fresco system, a few steps and important notes are described below.

After the new photocell hardware is swapped into the system, update the serial number within the nLight programming tab and Fresco Studio to ensure the programming is assigned to the new hardware.

May have to wait a few minutes, or possibly restart the Fresco Touchscreen which the new photocell is connected to in order for daylighting settings to take affect, and dim level changes be updated.

It may take up to 2 to 2.5 minutes before photocell control is resumed after swapping in the hardware.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request