Follow

Photocell controlled load not responding

If a load is assigned to be controlled by a photocell, the dimming output should normally respond to the combined photocell level and zone intensity level, such as the level set by a channel slider.

 

If the load appears to no longer be controlled by the photocell, it may be the photocell is no longer responding or has gone offline (wiring issue, power loss, failure of device, etc.). The lights will then track the light level of the channel.

Typically in an nLight system, the load will go to max brightness, in this case the load will go to that of the channel level / zone intensity.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request