Follow

Fresco master lighting control

A Fresco system typically is configured for room based control, however it can be programmed such that a single Fresco unit can be used as a master lighting control, global control station, centralized controller, etc.

The idea is to have a single Fresco Touchscreen unit setup to control the lights in all other areas where Fresco units are configured, this would allow individual room control of all rooms from a single Fresco unit. This would also allow turning on and off of the lights from a single centralized location for instance.

The operation can be accomplished by assigning a Fresco unit (the master unit) to have channels assigned to the zones or groups of each individual (standalone) room. The zones are unique across the Fresco network and therefore changes in one room, would update the zone levels in another room with the same zone id. The master controller in this case would have a channel assigned to control each zone or group of all the standalone rooms.

Note: based on size of space, number of zones or groups, it may not be possible to setup a single channel for every room and every zone.

Use the following as an example:

Room A

- Channel 1 = Zone 10

Room B

- Channel 1 = Zone 20

Room C

- Channel 1 = Zone 30

Master Controller, Room D

- Channel 1 = Zone 10

- Channel 2 = Zone 20

- Channel 3 = Zone 30

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request