Follow

Self test: Xpoint Wireless devices

There are two different tests that are embedded into xpoint wirless device software.

 

Press-hold - 2 to 5 seconds: This will make the fixture Dim down to minimum, then opens the relay for 1 second, then closed the relay and slowly ramps up. (5 sec) 

This test verifies the wiring is correct: and the fixture is operating properly

Note -: if this is the emergency model : First 90 minutes after a power cycle will automatically disable this test function.

 

Press-hold - 10seconds  The device will broadcast its current settings over the default RF network  (to be read in the XML-RPC). It will boardcast 

This will help find the settings to locate a device that the mesh isn't finding due to setting differences.

 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request