WSD: Why Do I Get Rapid Flash And Slow Blinks On My WSD Switch?

When programming the WSD switch, enter programming mode by holding the push-button from 5-10 seconds.  The LED will blink rapidly to show you have held the button down for a sufficient amount of time.  If you hold the button >10 seconds, the WSD LED will blink even faster, and the unit will enter "firmware blinkback" mode and blink back its firmware version.  The "firmware blinkback" will be a series of rapid and slow blinks.


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request