Follow

LC&D - Dual Occ-Sensor Solution

If there is a relay or multiple relays that must be controlled from 2 different DigiLinks because the occ-sensors are physically too far apart or the building is already wired and it is too late to make the occ-sensors run to the same DigiLink input, then they will need to use 2 separate relays per switch leg wired in parallel 1 relay controlled by each DigiLink.

 

When either relay or both relays close the lights will be ON.Dual_Occ_Sensor_Solution.jpg

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request