Follow

LC&D-CONNECTING a REMOTE SENSOR to a THERMOSTAT and a T-LINK

T-Link to Thermostat

 

The T-Link bus must be wired with Cat 5 or Cat 6 from the T-Link to the first Thermostat and all other thermostat in a daisy topography. You will need to use 1 pair of the Cat 5 landed on X1, X2.

 

Thermostat to 1st Remote Sensor

 

The Remote Sensor bus must be wired with Cat 5 or Cat 6 from the Thermostat to the 1st Remote Sensor using 1 ½ pair of the Cat 5, the pair landed on RS1 & RS+V, the ½ pair landed on the RS2.

Thermostat_12_-1a1.png

1st Remote Sensor to Additional Remote Sensors.

 

The Remote Sensor bus must be wired with Cat 5 or Cat 6 from the 1st Remote Sensor to all other Remote Sensor in daisy chain topography using 1 ½ pair of the Cat 5, the pair landed on RS1 & RS+V the ½ pair landed on AVG of the first sensor then to RS1 of the next; Continue this pattern for all additional Remote Sensors.

Thermostat_13-2a1.png

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request